- #UGEE DRIVER INSTALL PROBLEM INSTALL#
- #UGEE DRIVER INSTALL PROBLEM DRIVER#
- #UGEE DRIVER INSTALL PROBLEM FULL#
Please go to the display setting in the system control panel.
#UGEE DRIVER INSTALL PROBLEM FULL#
The red LED light will kept on shinning until full charge. Please plug the USB charge cable to the Pen and computer’s USB port to charge. If the stylus goes to low battery, the blue LED light on pen barrel will turn on. After finish setting, please reboot the computer, and use the drawing display as usual. If not, the pen and cursor will have some of inch distance. When using the mirror mode, the DPI of both monitors must be the same. Please unplug and re-plug your USB/dongle if the problem is not fixed please change to another USB port.ħ、When using the mirror mode, the pen and cursor have some of inch distance. This indicates that the USB port of your PC has a bad connection or the power from it is not stable. If you use USB to D-sub, DVI or HDMI trans adapter, please make sure it is in good condition before using.Ħ、Why is the LED of my tablet blinking continuously? Try to test pen display with another computer. Make sure one of VGA, DVI or HDMI cable has connected to both the pen display and computer, and be connected tightly. When the problem still exists, there should be hardware damage with the Artist or stylus.ĥ、My Pen Display shows no signal (The power light appears red.) If the stylus also can’t control the cursor even you have not installed the driver, please try to test the tablet using another computer.
#UGEE DRIVER INSTALL PROBLEM INSTALL#
When the system returns to the desktop, please connect the tablet to the computer directly (doesn’t need install driver) and test whether you can use the stylus to control the cursor or not.
#UGEE DRIVER INSTALL PROBLEM DRIVER#
Try to remove the driver and reboot the computer. If it always blinks, please unplug and plug again or try to connect it to another USB port. When the stylus is far away from the sensitive height of the tablet, please check the LED light of the tablet is on or off. If yes, please try to unplug and re-plug it to another USB port, or change another USB cable. Please make sure your USB cable has connected to computer? If not, please connect it. If your computer or notebook has no VGA, DVI or HDMI ports, you can buy a USB to VGA or HDMI trans adapter for using.Ĥ、When tablets connects to the computer, but the cursor of stylus can not move The USB cable is only for drawing-data, not for display data transmission, so you must connect both USB cable and one of the VGA, DVI or HDMI cable. (2). Explore → → Uninstall a program→ Ugee and choose įollow the instructions until uninstall is completed.ģ、My notebook has no VGA, DVI or HDMI ports, can I only plug the USB to use the Monitor Display? In the Coordinate function, select Absolute or Relative mode. Go to the “pen tablet setting-button” window. 1、How to switch between Absolute and Relative modes?
0 kommentar(er)
